![]() ![]() Open 2 of the 6 bags of Quickrete Mortar mix (containing sand) and pour them into your wheelbarrel. The next thing to do, is to mix your mortar. Next you will pour the 40lb bag of Quickrete cement mix into the hole (both inside the block holes and around the outside of the blocks), pour in the water per package instructions and mix with your trowel (add gravel or rocks to this mix as you go to bring it up to the level of the top of the block)ĭry fit (called dry bonding) the first two courses of bricks, alternating the stacks so you know how to lay them down. Now drive your rebar through each of the four holes of the block into the ground leaving 4-5" sticking up above the ground inside the holes. Place the two block inside and use your level to make sure they are both level front to back and side to side, you can push rocks or dirt underneath here and there to adjust level as needed. Enough to fit the two block in side by side and as level on the bottom as you can make it. You hole needs to be 8" deep by 16"x16" or a little larger. We had to remove an old masonry mailbox that had been ceremoniously destroyed by the back bumper of car. After you have decided where to put it you will have to dig a hole. The First thing you will need to do is figure out where you want your mailbox, consult with your local post office to find out what the regulations are, how close it should be to the curb, how tall the mailbox should be ect.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |